This wizard assists with any station copy (installing or backing up) by presenting a number of steps. The exact steps vary
by the direction of copy, as well your selections in wizard step dialogs. In each step, click Next to advance to the next step. As needed, click Back to return to a previous step and make changes, or click Cancel to exit from the wizard (no station copy performed).
NOTE: Use Cancel if you need to make a different selection to copy; this reruns the wizard.
The wizard’s Finish button is enabled only in the final step. When you click Finish, the related operations begin, and you see progress updates in the Transferring Station dialog. When complete, click Close in the dialog to exit the wizard.
NOTE: In the unlikely case where the source station config.bog file is currently in use (“locked”), the wizard opens in a state
where you must
Cancel to exit (no other steps are given).
- If installing a station, the source config.bog is locked if it contains unsaved changes (it is being edited elsewhere in
Workbench). After saving changes, you can try to copy again.
- If backing up a station, the source config.bog is locked if currently in process of being saved. You can retry the copy later.