In addition to the (default) Data Recovery Service Editor view, the DataRecoveryService also has properties on its Platform Service Properties view, see Figure 3.
Most of these properties are also on the Data Recovery Service Editor default view (see Figure 1). However, the following alarm-related configuration properties are accessible only via this view:
-
Alert On Replay
Default is
false. If set totrue, upon any controller boot sequence in which SRAM recorded data is discovered and played back, a corresponding alert is routed to the Alarm Class named in the Data Recovery Alarm Support container. Figure 4 shows details for such an example alert. -
Data Recover Alarm Support
This is the standard container slot for routing platform service-generated alarms or alerts, in this case an alert from the DataRecoveryService upon any controller boot sequence in which SRAM recorded data is discovered and played back. These properties work in the same fashion as those in an alarm extension for any control point.
