Update Network Settings

Use this menu option to access most of the same IP networking options as available in the Commissioning Wizard step “TCP/IP configuration”. When selected, you are prompted for each setting sequentially, starting with hostname, shown below.

Update Network Settings example in the Titan System Shell

JACE Network Configuration Utility  
Enter new value, '.' to clear the field or '<cr>' to keep existing value.

Hostname <localhost> : J8_East 
Domain <> : myDomain.net 
Primary DNS Server <> : 8.8.8.8 
Secondary DNS Server <> : 8.8.4.4 
Route <192.168.1.1> : 
Primary IPv6 DNS Server <> : 
Secondary IPv6 DNS Server <> : 
IPv6 Route <> :  

NET1 Ethernet interface (en0)   
 IP address (clear to use DHCP) <> : 192.168.1.36   
 Subnet mask <255.255.255.0> :   
 Enable IPv6 addressing on this adapter? (Y/n) :   
 IPv6 address (clear to use stateless autoconfiguration) <> :  

Enable NET2 (en1) interface? (y/N) : Y 
NET2 Ethernet interface   
 IP address (clear to use DHCP) <> : 172.15.16.36   
 Subnet mask <255.255.255.0> :   
 Enable IPv6 addressing on this adapter? (Y/n) :   
 IPv6 address (only 1 adapter may use IPv6 Autoconfiguration) <> :

**** IPv6 Autoconfiguration NOT supported on NET2 interface. 
IPv6 on NET2 will be disabled.

Confirm new configuration 
Hostname        : J8_East 
Domain          : myDomain.net 
Default Gateway : 192.168.1.1 
Primary DNS     : 8.8.8.8 
Secondary DNS   : 8.8.4.4 
Default IPv6 Gateway : 
Primary IPv6 DNS     : 
Secondary IPv6 DNS   :  

NET1 settings: 
IP Address          : 192.168.1.36 
Subnet Mask         : 255.255.255.0 
IPv6 Addressing assigned via Autoconfiguration  

NET2 settings: 
IP Address          : 172.15.16.36 
Subnet Mask         : 255.255.255.0 
IPv6 Addressing assigned via Autoconfiguration  

Save these settings? (Y/n) :

NOTE: After you save the network settings, they do not become active until you perform a reboot of the JACE controller. You can do this when you return to the main system shell menu, by selecting Reboot, menu option 6.

Update System Time"

If the commissioning process hasn't been completed yet, it is often important to set the current date and time (YYYYMMDDHHMM.ss). For example: 201510231536 for 23-Oct-2015 at 3:36pm UTC or 11:36 EDT.