Steps for each station List

This middle area of the Niagara Network Prototype View shows a one-line summary for each step to be run for each station specified in this job. In most provisioning jobs, you add one or more steps. As needed, you can also remove and reorder steps (when the job runs, steps execute in the top-to-bottom order).

Adding Job List Steps

Figure 33. New Job Step popup menu (Niagara Network Prototype View)

Add a provisioning job step by using any of the following methods:

Click the “+” (add) button below the list, and choose the step type from the New Job Step popup menu (see Figure 33). Note that all the same types of job steps are available as in the Niagara Network Job Builder, with the exception of the Copy Local File step).

For details about step types, see Niagara provisioning job steps.
Right-click in the steps list, select Add, and choose the step type from the popup menu.
Drag a file from Workbench’s Nav tree into the steps list (implicit Copy Supervisor File step).
Drag a software item (module or dist) from Workbench’s Nav tree that appears under the ProvisioningNwExt’s “Software” container, into the Job Steps List (implicit Install Software step).
Drag a ProvisioningRobot that exists in the station’s Config (component) architecture into the steps list (implicit Run Robot step).

Removing Job List Steps

Remove a provisioning job step using either of these two methods:

Click to select the step, then click the “X” (remove) button below the list.
Right-click the step, and select Remove from the popup menu.

Reorder Job List Steps

Reorder a selected job step by clicking the (up) or (down) arrow button at the bottom of the list. Or, right-click a job step and select Move Up or Move Down, as needed.

Job steps are executed in the same top-to-bottom order as defined in the two step lists: “initial steps” first, then “steps for each station”.