Buttons at the bottom of the Batch Job Step Log File View are described as follows:
-
— (always enabled) Click to go “up a level” to the Batch Job Log File View or Niagara Network Job View (the latter if job is running or recent).
-
— Enabled only if job is running. Clicking reloads the information from the job (available because this view cannot get new log entries as they are written on the Supervisor).
-
— Enabled if it was a Backup Stations step, and it completed successfully. Click for a confirmation dialog to install the station from the backup .dist saved in this job step (Figure 15).
Read the Restore Station confirmation carefully. There is no “undo” after restoring a station backup.
If you confirm to restore:
-
A provisioning job is queued to install the backup .dist.
-
The view changes to the Niagara Network Job View for the new (install backup) job.
-
If the step was a Run Robot step, these additional buttons are available at the bottom of the Batch Job Step Log File View or Job Step Details View:
-
— (always enabled) Click to view the program code of the ProvisioningRobot.
-
— Enabled after job has completed. Click to see the log output from the execution of the ProvisioningRobot.