Use the McQuay Point Manager to add, edit, and access McQuay proxy points under the Points extension of a selected McQuayDevice, or in a McQuayDeviceFolder. The McQuay Point Manager is the default view on both these components. To view, double-click the Points extension or McQuayPointFolder, or right-click and select ->.
For more details, see McQuay Point Manager.
By default, the following columns appear in this point manager:
-
Name
Niagara name of the McQuay proxy point or points folder.
-
Type
Niagara type of component, as either a McQuay Point Folder (for a folder) or a type of McQuay proxy point (either McQuay AI, McQuay AO, McQuay BI, McQuay BO, or McQuay Enum).
-
Out
Current last polled value (out slot) of a proxy point, reflecting status and facets.
-
Register Hex
Address register (in hexadecimal format) in the McQuay device where a data item resides.
-
Data Len Registers
Number of registers included for a data item (typically either 1 or 2).
-
Poll Frequency
Defined polling frequency, as either Normal (default), Slow, or Fast.
-
Enabled
Whether enabled (true, default) or disabled (false).
-
Facets
Assigned units (AI or AO), trueText and falseText (BI or BO), or enum range (Enum).
-
Tuning Policy Name
Assigned tuning policy (Default Policy, or other if available and assigned).
In addition, using the 
table options control, the following additional data columns are available:
-
Path
Station path of the proxy point or point folder component, relative to the root.
-
Enum Type
If the point type is McQuay Enum, reflects the selected McQuay enum type.
-
Device Facets
Not applicable (will be blank, as all raw McQuay data is integer and “unitless”).
-
Conversion
Niagara conversion type used, such as Linear, Default, or Reverse Polarity.
-
Fault Cause
If the point is in fault, explains why.