The McQuay Device Manager (Figure 5) is the default view for the McQuayNetwork, as well as any child McQuayDeviceFolder, and works similar to other device managers that do not support online device discovery. See “About the Device Manager” in the Drivers Guide for general information.
As needed, from this view use buttons and to make McQuayDeviceFolders and McQuayDevices, respectively. The figure below shows the dialogs when making a New device.
Defaults are like those shown in the Figure 6 dialog above, where:
-
Name is
McQuayDeviceorMcQuayDevicen(must be unique in the current parent container), and -
Master and slave L2 and L3 addresses appear as 0 and 255, respectively.
Change these values as needed to match the various MicroTech controllers you are adding to the network.
After adding one or more new devices, you can also reselect them in this view, and use the button to change name and address values in a similar Edit dialog, if needed. Also see McQuayDevice for more details on this device component.
In this view, go to the points manager of any McQuayDevice shown by double-clicking on its 
(Points) icon under the Exts column. See McQuay Point Manager.