|
|
What-If Analyzer
The purpose of the What-If Analyzer is to allow you to look at calculated costs (and components that are used to determine costs) and make “trial” adjustments to these components to see the effect that these changes have on the overall costs for a meter.
As with other reports, you can run the What-If Analyzer on a single meter, or you can aggregate meters and run the report on the aggregate. Figure 1-22 shows an example of the What-If Analyzer report. Calculated costs are listed, by billing cycle, side-by-side with the “Adjusted Cost” that you have created by adjusting: demand, consumption, or a component fee.
Figure 1-22 What-If Analyzer report.
Like other reports, the What-If Analyzer reports may be adjusted and run again, saved, or discarded.
|
|
|
|