Set Module Filters
This selection from the Platform Administration view lets you globally change the “runtime profile” types for software modules on the connected platform. This affects how
much file space consumed by installed Niagara modules.
NOTE: Typically, enabled runtime profiles you set this once during initial JACE commissioning, then never change it.
Figure 65. Update Enabled Runtime Profiles dialog
- For any Windows-based host (providing it has hard drive for file storage), you typically want all runtime profiles enabled for the fullest possible content level, meaning including all documentation (doc+ui+runtime).
- For a JACE controller, with more limited flash-based file storage, in certain scenarios you may wish to change the enabled runtime profiles. Selection produces the dialog above.
Module content level is one of the following, from largest to smallest:
doc+ui+runtime—Typically appropriate only for Windows-based platforms.ui+runtime—Appropriate for any JACE that is to run the Web Service. This is typical for any "standalone" JACE , as well as any JACE that serves PxPages directly to browser clients.runtime—Typically only for a JACE controller not running Web Service (all PxPages served instead by a Supervisor).