Status and Runtime Data area
The bottom area of the GPRS Modem Configuration view contains debug-level data from the low-level GPRS modem driver ("GPRSD")
on the JACE.
Figure 28. Tabs near the bottom of the GPRS Modem Configuration view
This data is found on two separate tabs: GPRS Status and GPRS Runtime Data.
- Information on these tabs updates only when you load or refresh this view.
- Refer to the section "GPRS Status and Runtime Data tabs" in the Engineering Notes document "GPRS modem option" for reference details on the various data sections below.
GPRS Status
Figure 29. GPRS Status tab in GPRS Modem Configuration view (or Gprs Platform Service Plugin)
The GPRS Status tab in the platform GPRS Modem Configuration view (or Gprs Platform Service Plugin) shows data separated into the following categories:
- PPPD Data - This section in the GPRS Status tab shows "ppp" (point to point protocol) related data.
- Modem Data - This section shows data about the installed GPRS modem option card.
- SMS Data - This section shows data about failed SMS messages.
- Monitor Data - This section in the GPRS Status tab shows various data, using various terms including ME (mobile equipment), MS (mobile station), and PLMN (public land mobile network).
GPRS Runtime Data
Figure 30. GPRS Runtime Data tab in GPRS Modem Configuration view (or Gprs Platform Service Plugin)
The GPRS Runtime Data tab in the platform GPRS Modem Configuration view (or Gprs Platform Service Plugin) shows status data for the modem, including its RSSI (Received Signal Strength Indicator, from 0 to 5), whether Roaming is active, and its unique IMSI, IMEI and SIM values.