CHC Zone Control

Description

To configure heating and cooling setpoints.

Purpose

Configure the heating and cooling setpoints for the Occupied, Standby, and Unoccupied operating modes.

Mode

Configuration can be performed with the wizard Off-line or On-line.

Procedure

1. Click the Zone Control button on the left pane to open the Zone Control Configuration page.
2. Enter information into available fields.
3. Click Commit to save the settings or Reset to revert to the last saved settings.
4. Click Next to display the Miscellaneous Configuration page or Back to display the Switching Levels Configuration page.

Fields 

Setpoints can range from 10 Deg.C to 35 Deg.C (50 Deg.F to 95 Deg.F).

Also specify dew-point temperature setpoint and a safety band to be used in case the dew-point calculation fails or a humidity sensor is not available. These fields are not used when the controller is not configured for ceiling protection.

Back