If you have a specific station database ready to install in the JACE, you can specify it at this step in the wizard. Or, simply accept the default “(Don’t transfer a station)” and click . (You can create a station later using the New Station Wizard, and install it using the platform’s Station Copier.)
To specify a station database to install
At the Station Installation step (Figure 10), do the following:
-
Click the Station drop-down control and click the name of a station database on your PC.Listed are station subfolders under your PC’s local Niagara stations folder.
-
If you select a station, the following additional selections are available (Figure 11):
-
New Name — Either leave at same station name as local copy, or type in a new station name.
-
START AFTER INSTALL — Pre-selected as cleared. However, the station starts after the commissioning completes.
-
AUTO-START — If enabled (the default), the station starts every time the JACE is rebooted.
-
-
Click the button to continue.
A dialog asks which station files to copy (Figure 12), where you can select one of the following:
-
Copy files from selected directories — Allows you to specify which subfolders under that local station that are copied. It produces a “tree” selection dialog (Figure 13) upon button.
-
If you choose this, click folder controls to expand and contract as needed.
-
Selected folders appear with an “X” and unselected folders show an empty folder box.
-
-
Copy every file in the station directory and its subdirectory — The default, most typically used.
-
Copy only the “config.bog” station database file — Copies only the station configuration (components), and not any supporting folders/files like px files, html files, and so forth.
-
Click the button for the next step, Install lexicons (or if skipping that step, Select modules).
