To start the Commissioning Wizard

From Workbench with the JACE platform open, to start the Commissioning Wizard do the following:

1. In the Nav tree, right-click on Platform and select Commissioning Wizard.

   The dialog box Commissioning for “<IP address>” appears (Figure 3).

   Figure 3. Commissioning Wizard (default selections shown for new JACE)

   
   
   
   
   

   By default, all steps are preselected except lexicon installation (for language support). Steps are executed in the order listed in the wizard.

2. As needed, click to include or omit steps. For a new JACE, you typically accept all default selections.

   Commissioning steps include:

   • Request or install software licenses — Preselected for any new JACE.

   • Set module content filter level — Recommended.

     It is important not to omit this step, especially for any JACE running the WebService.

   • Install a station from the local computer — Recommended.

   • Install lexicons to support additional languages — Recommended only if you are using lexicon sets (files) instead of lexicon modules, typically for non-English language support.

   • Install/upgrade modules — (always preselected, whenever wizard is run). To select the software modules, and optionally any lexicon modules for a AX-3.7 or later JACE.

   • Install/upgrade core software from distribution files — Preselected for any new JACE.

   • Sync with my local system date and time — Preselected in most cases (new JACE for example).

   • Configure TCP/IP network settings — Recommended.

   • Configure platform daemon authentication method — Do not skip this for any new JACE!

3. Click the Next button to continue. With wizard selection defaults, this is Install license.