To specify a station database to install

At the Station Installation step (Figure 9) in the Commissioning Wizard, do the following:

1. Click the Station drop-down control and click the name of a station database on your PC.Listed are station subfolders under your PC’s local Niagara stations folder.

   Figure 10. Station Installation dialog (station selected)

   
   
   
   
   

2. If you select a station, the following additional selections are available (Figure 10):

   • New Name — Either leave at same station name as local copy, or type in a new station name.

   • START AFTER INSTALL — If enabled, the station starts after the commissioning completes.

   • AUTO-START — If enabled, the station starts every time the JACE is rebooted.

3. Click the Next button to continue.

   Figure 11. Station Installation dialog (copy options)

   
   
   
   
   

   A dialog asks which station files to copy (Figure 11), where you can select one of the following:

   • Copy files from selected directories — Allows you to specify which subfolders under that local station that are copied. It produces a “tree” selection dialog (Figure 12) upon Next button.

     Figure 12. Station Installation dialog (select subfolders)

     
     
     
     
     

     • If you choose this, click folder controls to expand and contract as needed.

     • Selected folders appear with an “X” and unselected folders show an empty folder box.

   • Copy every file in the station directory and its subdirectory — The default, most typically used.

   • Copy only the “config.bog” station database file — Copies only the station configuration (components), and not any supporting folders/files like px files, html files, and so forth.

4. Click the Next button for the next step, Select modules.