IP Port tab
This tab configures the BACnet/IP link layer used by the controller, providing that the
Enabled property (in BACnet Network tab) is set to true.
Figure 197. IP Port tab
To access this view, click , followed by clicking the IP Port tab.
Properties
| Property | Value | Description |
|---|---|---|
| Enabled | true or false |
Turns the feature on (true) and off (false). |
| Status | read-only | Reports the condition of the entity or process at last polling.
{ok} indicates that the entity is licensed and polling successfully. {down} indicates that the last poll was unsuccessful, perhaps because of an incorrect property. {disabled} indicates that the Enable property is set to false. {fault} indicates another problem. Depending on conditions, multiple status flags may be set including {fault} and {disabled}, combined with {down}, {alarm}, {stale}, and {unackedAlarm}. |
| Fault Cause | read-only | Reports the reason why a network, component, or extension is in fault. Fault Cause is blank unless a fault exists. |
| Network Number | number from 1 to 65534; default value is -1 (inoperative) | Specifies a unique network number across the entire BACnet internetwork for the BACnet/IP network. The . |
| Adapter | NET1 (default) or NET2 |
Specifies which of the two physical Ethernet ports on the controller is used for BACnet/IP communications. |
| UDP Port | port number; defaults to 0xBAC0 (decimal 47808) | Specifies the UDP (user datagram protocol) port used by BACnet/IP. You can specify another port, if needed (say an existing BACnet/IP network is using another UDP software port). |
| IP Device Type | drop-down list: BACnet device (the default), a BBMD (BACnet Broadcast Management Device) or BACnet Foreign Device.
|
Defines the type of BACnet/IP device Generally, the default Standard should by used. |
| Bbmd Address | number | Sets the Bbmd (BACnet Broadcast Management Device) address. This address is only required when the system is being used as a BACnet Broadcast Management Device. |