Setting station connection credentials
This procedure creates a provisioning job to set the username and password for the station (foxs or fox) connection credentials
for each station proxy in the job on the Supervisor’s Niagara Network. No changes are made to the remote station. Existing station connections are reset to use the new credentials as part of
this step execution.
Prerequisites: The BatchJobService is available under Services. The ProvisioningNwExt component is available under the NiagaraNetwork. The Niagara Network Job Builder (one-time) or Niagara Network Prototype View (reoccurring job) is open.
Perform the following steps:
- In the Niagara Network Job Builder window, top pane, Provisioning steps to run, click add (
).The New Job Step window opens. - Click the Set Station Connection Credentials step and click OK.The Set Station Connections Credentials window prompts for the new username and password for the station connection to the remote device.
- Enter a username and password for the station connection and click OK.
- In the bottom pane, Stations to include in the job, click add ().The Add Device window opens.
- Click to select the stations and click OK.
- To initiate the provisioning job, review your choices and click the Run Now button at the bottom of the Niagara Network Job Builder view.
The view changes to the Niagara Network Job View, where steps and results appear as they are executed.