Removing a property

Starting in Niagara 4.7, this procedure creates a provisioning job to remove a property value of a component on each remote station in the job.

Prerequisites: The BatchJobService is available under Services. The ProvisioningNwExt component is available under the NiagaraNetwork. The Niagara Network Job Builder or Niagara Network Prototype View is open.

The property that you remove is a dynamic property. The target must be a component and the property must be dynamic.

Perform the following steps:

In the top pane, Provisioning steps to run, click add ().
The New Job Step window opens.
Select the Remove Property step and click OK.
The Remove Property window opens.
Enter the slot path (Target ORD) for the target component, the Property Name to remove, and click OK.
In the Provisioning steps to run pane, the newly added job appears.
In the bottom pane, Stations to include in the job, click add ().
The Add Device window opens.
Select the stations for which to remove the property value and click OK.
To initiate the provisioning job, review your choices and click Run Now at the bottom of the view.
The view changes to the Niagara Network Job View, where steps and results appear as they are executed.