Prerequisites: The
Supervisor PC is licensed for provisioning and has the required modules installed.
- If it is not already open, in
Workbench, open the
Supervisor station.
- Open the provisioningNiagara palette in the palette side bar.
- Expand Config and double-click Services
The Service Manager opens.
- Do one of the following:
- If a BatchJobService is already listed, verify that it is enabled (status ok).
- If no BatchJobService exists, from the palette, drag the BatchJobService onto the station’s Services folder. In the popup Name window, rename the service—or use the default name and click OK.
A BatchJobService (or whatever you named it), appears under your Services folder.
- Right-click the BatchJobService and click .
- Expand Job Queue and set the service’s
Max Threads property to a value greater than 1, say 2 or 3 and click Save.This allows more than a single provisioning job to run concurrently.
- To monitor provisioning alarms, change
Alarm Class from the default Default Alarm Class to another alarm class