This procedure describes how to install and configure the Nrio Trunk on the ACE driver.
Prerequisites:
- You are connected to the station running on an Edge device.
- There is an existing AceEdgeNetwork with ACE App installed and running.
- The aceEdge palette is open.
Perform the following steps:
- Under the station’s Drivers node, open a Property Sheet view of the AceEdgeNetwork.
- From the aceEdge palette, drop the NrioTrunk component onto the network.
- Open a Property Sheet view of the NrioTrunk and set
Use Ace Nrio to “true”.
NOTE: Leave the default value of Trunk and Port Name properties unchanged.
The ACE App is configured for Nrio.