Installing ACE software

The following procedures describe the steps to install the ACE software on a released device as well as on a pre-released device.

Refer to the Niagara Edge 10 Install and Startup Guide and follow the instructions on “Setting up a single device using commissioning”, and “Running the Commissioning Wizard”.
Connect to the station running on the Edge device.
In the station Drivers node, remove the existing EdgeIoNetwork
Open the aceEdge palette and drag the AceEdgeNetwork to the Drivers node.

Update the Edge device with the Niagara 4.8 software
In the station Drivers node, remove the existing EdgeIoNetwork.
Open the aceEdge palette and drag the AceEdgeNetwork to the Drivers node.
Figure 4. AceEdgeNetwork available in aceEdge palette