entsec-ReplicationService (Replication Service)
This component monitors and configures the ReplicationService.
Figure 69. Replication Service properties
To access these properties, expand in Nav tree and double-click ReplicationService.
In addition to the standard properties (Status, Fault Cause, and Enabled), these properties support this service.
| Property | Value | Description |
|---|---|---|
| State | read-only | Reports the current state of the ReplicationService. |
| Execution Time | additional properties | Uses a control time trigger to configure when to perform a replication job.
Getting Started with Niagara documents the control-TimeTrigger component. |
| Last Attempt | read-only | Reports the last time the system attempted to run a replication job. |
| Last Replication | read-only | Reports the last time a replication job ran. |
| Last Failure | read-only | Reports the last time a replication job failed. |
| Time Sync overlap | hours minutes seconds (defaults to one minute) | |
| Event Driven Interval | hours minutes seconds (defaults to five minutes) | |
| Replication Failure Alarm | additional properties | Configures alarm source information for a replication failure.
The Niagara Alarms Guide documents the Alarm Source Info component. |
| Replication Overrun Alarm | additional properties | Configures alarm source information for a replication overrun.
The Niagara Alarms Guide documents the Alarm Source Info component. |
| Replication Overrun Limit | number (defaults to 5000) | Sets a limit for replication overruns. |
| Instant Replicator Interval | hours minutes seconds (defaults to 30 seconds) | |
| Replication Executor Limit | number (defaults to 5) |