kitLon-LonEnumTodEvent (Lon Enum Tod Event)
This component can take inputs from EnumSchedule outputs (Out, Next Value), and link them to a Lon device’s nvi that uses
SnvtEnumTodEvent.
To use, copy this component from the kitLon palette into the LonNetwork, and link it between EnumSchedules and Lon devices.
Figure 53. LonEnumTodEvent properties
To access these properties, right-click LonNetwork and click , then expand LonEnumTodEvent.
In addition to the standard properties (Status and Fault Cause) these properties are unique to this component.
| Property | Value | Description |
|---|---|---|
| Update Time | hours minutes seconds (defaults to 10 seconds) |
Sets the frequency with which the driver updates the time.
|
| Current State | read-only |
Reports the current state of the device or component.
|
| Next State | read-only |
Reports the next state of the device or component.
|
| Next Time | date |
Configures the time of the next event.
|
| Max Time To Next State | date and time with calendar to make selection easy |
Specifies the maximum time to wait before rewriting a proxy point value in case nothing else has triggered a write. Any write
action resets this timer.
If left set to the default, the driver disables this rule resulting in no timed rewrites. |
| Tod Event | additional properties | Configures the event state. Refer to a separate topic. |