This procedure links a trigger schedule to a component in the same wire sheet.
Prerequisites: You have a configured trigger schedule and a target component (point or extension).
- In the Wire Sheet, mouse over the trigger schedule’s
Trigger slot until highlighted.
- Click and drag the link wire from the trigger schedule to the bottom of the target component, and release the mouse button.
A Link window opens. The source (left) side has the trigger schedule’s Trigger slot preselected.
- In the target (right) side of the Link window, click on the slot of the target component.
- With both source and target sides selected in the Link window, click OK.
The target component (point or extension) is now linked to the trigger schedule.