Mbus Proxy Ext

Mbus Proxy Ext

This extension, which configures point properties is located beneath any Mbus proxied point.

This extension is visible once you add a point to the point database.

Property	Value	Description
Status	read-only	Indicates the condition of the component at the last check. `{ok}` indicates that the component is licensed and polling successfully. `{down}` indicates that the last check was unsuccessful, perhaps because of an incorrect property, or possibly loss of network connection. `{disabled}` indicates that the `Enable` property is set to `false`. `{fault}` indicates another problem. Refer to `Fault Cause` for more information.
Fault Cause	read-only	Indicates the reason why a system object (network, device, component, extension, etc.) is in fault. This property is empty unless a fault exists.
Enabled	`true` or `false`	Activates and deactivates use of the component.
Conversion	Drop-down list	Defines how the system converts proxy extension units to parent point units. `Default` automatically converts similar units (such as Fahrenheit to Celsius) within the proxy point. NOTE: In most cases, the standard `Default` conversion is best. `Linear` applies to voltage input, resistive input and voltage output writable points. Works with linear-acting devices. You use the Scale and Offset properties to convert the output value to a unit other than that defined by device facets. `Reverse Polarity` applies only to Boolean input and relay output writable points. Reverses the logic of the hardware binary input or output. `500 Ohm Shunt` applies to voltage input points only. It reads a 4-to-20mA sensor, where the Ui input requires a 500 ohm resistor wired across (shunting) the input terminals. `Tabular Thermistor` applies to only a Thermistor input point and involves a custom resistance-to-temperature value response curve for Type 3 Thermistor temperature sensors.
Tuning Policy Name		Selects the tuning policy for this point.
Read Value	read-only	Displays the actual value imported from the device, and formatted based on device facets. The display accords with the point facets.
Mbus Unit	text	Displays the unit as defined in the Mbus specification. The unit is text only and can be changed for information purposes.
Description	text	Describes the point. This text can be changed.
Orthogonal Description	text	Displays the Orthogonal Description as defined in the Mbus specification. This can be changed.
Number Type	read-only	Reports the type of number for the input.
Message Slot Number	read-only	Refer to the manufacturer's documentation.
Record Number	read-only	Refer to the manufacturer's documentation.
Function	read-only	Refer to the manufacturer's documentation.
Exponent	read-only	Reports value information provided by the device manufacturer.
Manu Spec Def Element Ord	read-only	Refer to the manufacturer's documentation.
Device Mode	read-only	Refer to the manufacturer's documentation.
Out	read-only	Reports the current value and status of the point.