Using the applet to play back applet-rendered videos

You may use the Niagara Web Launcher and Java applet to play back applet–rendered video clips associated with alarms.

Prerequisites: The applet–rendered video clip already exists.

The HTML5 Alarm Console is not available using Web Launcher.

Perform the following steps:

Open your browser and enter the station’s IP address in the Address field at the top of the browser.
The Login window opens.
Click the link below the window that reads, “To connect using Niagara Web Launcher click here.”
It may take a while for the Niagara Web Launcher to load and open a window for entering the station’s URL.
If you see an error message, click the browser’s back button.
Enter the station’s IP address in this box and click Go
A different login window opens.
Enter the station password and click Login.
The web UI opens supported by the Web Launcher.
Do one of the following:
- Click Monitoring > Alarm Console.
- Click System Setup > Alarm Setup, click Alarm Consoles, double-click the ConsoleRecipient row in the table, and click the View Alarm Console button.
The applet loads (this may take a bit of time) and opens its Alarm Console view. Both access methods load the same applet-based Alarm Console.
Double-click the motion-detected alarm row in the table.
A pop-up window opens with the recorded video.
The screen capture shows the applet Alarm Console with an open video clip.