Configuring intrusion zone alarms to appear on the Supervisor
This procedure explains how to configure an intrusion zone in a remote host controller so that intrusion alarms appear in
the Supervisor’s alarm console.
Prerequisites: The remote host controller is installed, you are connected to its station, the intrusion zone already exists.
- To assign the relevant Supervisor from the main menu, click , double-click an existing intrusion zone, click the Grouping tab, click Assign Mode (
), select the Unassigned Supervisor station, and click Assign (
). - To route intrusion zone alarms to the Supervisor, click the Recipients tab, click Assign Mode (), select an unassigned Supervisor recipient, and click Assign ().
- Click Save.
- Replicate from the Supervisor.The Supervisor station can view alarms from the remote intrusion zone.
- In Supervisor, click , double-click the intrusion zone in the table, click the Recipients tab, and assign the console recipient or other applicable recipient.