Associating the display with its zone
The station that controls your intrusion zone(s) is the one to which your
Prerequisites: You created your authentication certificate and have set up your display. You are working in the web UI and
are connected to the station that manages your building’s intrusion zones.
- If needed, set up one or more intrusion zones following the procedure earlier in this chapter.
- To add a display, navigate to Controller Setup menu, select and click the Add button (
).The Intrusion Display tab opens. - Configure these properties:
Give the display a
Display Name.Change
Smart Key Devicetonone. - To add an intrusion PIN or PINs, select
trueforArming Pin Required. - To assign the intrusion zone to a display, click the Intrusion Zones tab, click the Assign Mode button (
), select an unassigned zone and click the Assign button (). - To save these changes, click Save.The system adds the display to the database, shows it the top of the view, and adds it as a component node under the AlarmService.
- Repeat these steps for each display.
The next step is to create the onscreen keypad.