Adding points to an intrusion zone

Any point to be monitored as part of an intrusion zone must be added to the intrusion zone.

Prerequisites: The intrusion zone record in the local station exists. You are using the web UI connected to the remote host station.

Navigate to Controller Setup > Intrusion Setup > Intrusion Zones.
The Intrusion Zone view opens.
Double-click the zone to which you are adding the point.
The edit view for the zone opens.
Click the Points tab and click the Assign Mode button ().
The Unassigned pane opens with the list of available points.
Select one or more points to assign and click the Assign button ().
The assigned points move to the Newly Assigned pane.
To delay the alarm on a point when the system arms, select the point, and click the Edit Entry Point button ().
To cause the alarm on a point to be always enabled regardless of the arm/disarm state, select the point and click the Edit Always Armed button ().
Extend the zone to include readers, other points, or relays that are under the station.
To complete adding points to the intrusion zone, click Save.