Adding and editing a SmartKey device
This procedure describes how to add Smart Key devices to the system database. You may add Smart Key devices while the device
itself is off-line or online. Each SmartKey device has an ID, which you assign at the device. If the SmartKey ID has been
assigned but you do not know it, and the device is currently online, use the discovery process to add the device instead of
this manual process.
Prerequisites: You are logged in to the remote station.
- Under the Controller Setup menu, select .The SmartKey Device Manager - Database view opens.
- Click the Add button (
).The Intrusion Display tab opens. - Enter an identifying
Display Namefor the device, selectSmartKey Devicefrom theSmart Key Devicedrop-down list. - To require a PIN when the device is used to arm and disarm the intrusion zone, select
trueforArming Pin Required. - To assign the intrusion zone to the display/keyboard device, click the Intrusion Zones tab, click the Assign Mode button,
select an unassigned zone, and click the Assign button ().
- To save the record to the database, click Save.One new device is added under the database at the top of the view.