Adding a Relation using drag and drop
You can add a relation between two components within a Wire Sheet simply by dragging a connector from lower end of one component
to the lower end of another.
Perform the following steps:
- In a Wire Sheet view, click the
- On the desired “Relate To” component, click the component’s footer and drag to the component footer for the desired “Relate
From” component.A Relation dialog appears.
- From the pull-down list, click on the desired Relation Id and click OK.
NOTE: This pull-down list is populated from the Relation Definitions defined in the selected Tag Dictionary.
In the Wire Sheet view, the relation is shown as a dashed line between the two components. Both of the components have the
Relation Id for the slot displayed name.
