kitControl-StatusEnumToStatusNumeric

This component converts a StatusEnum Out value to a StatusNumeric In value.

StatusEnumToStatusNumeric is available in the Conversion folder of the kitControl palette.

Figure 35. StatusEnumToStatusNumeric properties

Property Value Description

Facets

Config Facets window (defaults to null for units and one decimal place of precision)

Property	Value	Description
Facets	Config Facets window (defaults to null for units and one decimal place of precision)	Selects units and configures how the value displays: `units` defines the measure from `acceleration` to the `volumetric flow.` `precision` defines the number of decimal places. This configuration applies to the `In` property value.
Out	read-only number	Displays the converted target status numeric value.
In	number and null definition (defaults to 0)	Displays the source status enum value. When null is checked, the value displayed defaults to the incoming value from the device. If you remove the check mark you can configure the`In` value.

Selects units and configures how the value displays:

units defines the measure from acceleration to the volumetric flow.

precision defines the number of decimal places.

This configuration applies to the In property value.

Out read-only number Displays the converted target status numeric value.

number and null definition (defaults to 0)

Displays the source status enum value.

When null is checked, the value displayed defaults to the incoming value from the device. If you remove the check mark you can configure theIn value.

kitControl-StatusEnumToStatusNumeric

Figure 35. StatusEnumToStatusNumeric properties

Related Links