kitControl-Psychrometric

kitControl-Psychrometric

This component You can use it to support applications that need to calculate the properties of moist air using given temperature and humidity inputs.

Psychrometric is available in the Energy folder of the kitControl palette.

Figure 49. Psychrometric properties

Property	Value	Description
Unit Select	drop-down list (defaults to `English`)	Selects units of measure.
Temperature Facets	Config Facets window	Selects units and configures how the value displays: `units` defaults to temperature. `precision` defines the number of decimal places of temperature. `min` defines the lowest temperature allowed. `max` defines the highest temperature allowed. This configuration applies to `Outside Temp`, This configuration applies to the `In Temp` property value.
Humidity Facets	Config Facets window	Selects units and configures how the value displays: `units` defaults to percentage of relative humidity (%RH). `precision` defines the number of decimal places of humidity percentage. `min` defines the lowest humidity allowed. `max` defines the highest humidity allowed. This configuration applies to `In Humidity` property value.
In Temp	number of degrees of temperature (defaults to 0.0 degrees F) and null definition	Defines the input temperature. When null value is checked, the value displayed defaults to the incoming value from the device. If you remove the check mark you can configure the `In` value.
In Humidity	percentage of humidity (defaults to 0.0 percent RH) and null definition	Defines the input humidity. When null value is checked, the value displayed defaults to the incoming value from the device. If you remove the check mark you can configure the `In` value.
Out Dew Point	nan (not a number) or degrees (defaults to nan) and null definition	Reports the calculated dew point temperature. This value requires valid `In Temp` and `In Humidity` values. When null value is checked, the value displayed defaults to the incoming value from the device. If you remove the check mark you can configure the `In` value.
Out Enthalpy	nan (not a number) or BTU/lb (defaults to nan) and null definition	Reports calculated enthalpy. This value requires valid `In Temp` and `In Humidity` values. When null is checked, the value displayed defaults to the incoming value from the device. If you remove the check mark you can configure the`In` value.
Out Sat Press	number of psi (pounds per square inch) (defaults to 0.019) and null definition	Reports calculated saturated pressure. This value requires a valid `In Temp`. When null value is checked, the value displayed defaults to the incoming value from the device. If you remove the check mark you can configure the `In` value.
Out Vapor Press	nan psi and null definition	Reports calculated vapor pressure. This value requires valid `In Temp` and `In Humidity` values. When null value is checked, the value displayed defaults to the incoming value from the device. If you remove the check mark you can configure the `In` value.
Out Wet Bulb Temp	nan or degrees (defaults to nan) and null definition	Reports calculated wet bulb temperature. This value requires valid `In Temp` and `In Humidity` values. When null value is checked, the value displayed defaults to the incoming value from the device. If you remove the check mark you can configure the `In` value.