Index | Prev | Next

Upgrading the Cloud Connector to use Niagara Cloud Honeywell Sentience Driver

This procedure is only necessary if your Niagara 4.3 installation included the cloudConnector/cloudSentienceConnector modules for Backup as a Service, and you have subsequently upgraded to Niagara 4.4.
Prerequisites:
  • The cloudSentienceConnector palette is required.

 
NOTE: If either of the following is true, then you do NOT need to perform this procedure:
  • If you installed the cloudConnector/cloudSentienceConnector modules in Niagara 4.4 or greater.
  • If you are using a “legacy” JACE (i.e., JACE-3, JACE-6, or JACE-7; basically anything other than a JACE-8000 or Supervisor), then you cannot use the Niagara Cloud Honeywell Sentience Driver, so this procedure is not necessary. Also, if you are not configuring the JACE-8000 or Supervisor for Niagara Cloud Honeywell Sentience Driver then it is not necessary to perform this procedure.

 

Perform the following steps:
  1. In the Open Palette window, click Browse to locate and open the cloudSentienceConnector palette.
  2. Drag the MessageClientUpgrader onto the ConnectorImpl child of the installed CloudConnector service.
  3. Right-click on the MessageClientUpgrader, and select Actions > Switch To Iot Hub Message Client

The CloudConnector is upgraded. Typically, this is done only once and afterwards you can delete the MessageClientUpgrader component.

Related Links

  • cloudIotHubDep-MessageClientUpgrader (Parent Topic)

    • Index | Prev | Next