control-EnumPoint
EnumPoint is a basic read-only control point, with default slots: Facets, Out, and ProxyExt.
This point is available in the Points folder of the control palette and usually resides in a device’s Points folder.
Figure 209. Enum Point Property Sheet
You can access these properties in the Property Sheet by expanding and double-click on EnumPoint.
You can access these properties wherever numeric point is used. The enum point values can be given in operating range of the component.
| Property | Value | Description |
|---|---|---|
| Facets | Config Facets Window | Defines a range of enumerated states (enum values). |
| Proxy Ext, Out | value | Reports a value in the enum range and status, such as fault, overridden, alarm, and so on. If no status flag is set then status is considered normal and reports {ok}.
|