Installing software modules

This procedure describes downloading and installing required software modules and restarting the station on a PC.

Prerequisites:

Internet connectivity
An existing user account on the Niagara Community software portal.
NOTE: A user account on the Niagara Community software portal is needed only for non- Forge Connect installations. Forge Connect installations do not use this software portal.

In the web browser, log in to the Niagara Community software portal (https://www.niagara-community.com) and click Software (located upper right).
Scroll down to locate the nCloud Honeywell Sentience Driver software and click on the appropriate .zip file link depending on your software release version. For example, for Niagara 4.9 the .zip file is: nCloud_Honeywell_Sentience_Driver-4.9.0.2.zip
The zip file downloads to your system.
In your Windows user downloads folder (C:\Users\[UserName]\Downloads), right-click on the .zip file and extract the contents to your SysHome installation folder (Niagara/Niagara4 x.x).

NOTE: Install only Niagara Cloud Honeywell Sentience Driver-4.9.0.2 on Niagara 4.9or higher
If the system displays a prompt to Overwrite any existing previous versions?, click OK.
The nCloudDriver software modules and palettes are ready to use.
Restart the station.

Once the station restart is complete, you can proceed to install and configure the CloudConnector, NiagaraCloudNetwork, and CloudSentienceDevice.

Installing software modules

Related Links